Operating Flow Steps of Flying Man Photoploymer Flexo Resin Plate Making Machine

Operating Flow Steps of Flying Man Photoploymer Flexo Resin Plate Making Machine

Step 1:Back exposure 60 seconds (according to the actual plate instructions, and light power to adjust).

Step 2:Put the photographic plate, fix the position of the photographic plate and the plate below, open the vacuum pump, and apply the vacuum film to vacuum.

Step 3:Push the sliding door back and turn on the burst light (the time is adjusted according to the requirements of the plate manual and the light power).

Step 4:Put the double-sided tape on the back of the exposed plate, then stick it on the aluminum plate, cover the cover, and click the brush to start (120 seconds).

Step 5:Put the washed plate into the oven for dehumidification.

Step 6:The flood dry plate in UV adhesive layer to remove the adhesive, and then put the exposure layer for curing, and then can be used.