No power supply?
1, check the power connection plug contact is good?Check whether the fuse is broken?
Power supply, but unable to start, sensor error, cutter block sliding sleeve stuck or no air pressure?
1, check whether the cylinder is ventilated, if not, please open the valve.Check whether the sliding sleeve of the cutter block is stuck, and fill the sliding sleeve with lubricating oil.[ Computer slicing machine manufacturer ]
No material alarm?
1, whether the material is used up, please replace the new material.
2. Check whether there is any material or pressure plate in the slot.
3, if all normal check whether the travel switch is stuck did not bounce back.
Four, punching error?
1, check whether there is air pressure or punching frame stuck.
Five. Error of rotary tool sensor?
1. Check whether the baffle of the rotary cutter inductor is off-position or the upper rotation is stuck.
2. The drive plate fuse has not been burnt out.
Six, the screen surface does not display?
1. Check whether the transformer output is powered or the socket is loose.
7. Can't cut the tape?
1, check whether the air pressure is up to, if not, please increase the air pressure.Check whether the blade is sharp. The blade should be sharp.
2. Whether the hot knife blade is heated and whether the hot knife blade is in contact with the platform.The blade should be heated and the blade should be in contact with the platform.[cutting machine manufacturer]
Cut only one side of the tape?
1, (hot knife) : check whether the cutter platform has a high or low, if so, please adjust the adjusting screw here below the platform to cut continuously the side of the appropriate downward screw, or in the high side of the appropriate upward loosen the screw.After adjustment, tighten the nut again.
Nine, cut off length and set value is different?
1. Loosen the roller or use belt feeder to assist feeding.Enable compensation.
Ten, cut the length is not consistent?
1. Slow down the feeding speed, relax the gear plate, and it is necessary to assist the feeding with the distribution belt machine.[ Computer slicing machine manufacturer ]
11. When cutting off the trademark, the cutting line is not cut off.
1. Move the sensor to the direction of the knife edge, which is equivalent to the gap gap distance.Trademark printing is not standard.Print standard logos are recommended.
XII. When cutting off the trademark, cut off beyond the cutting line?
1. Move the sensor in the opposite direction of the blade, which is equivalent to the gap distance, and the trademark printing is not standard.Print standard logos are recommended.[Strip cutting machine manufacturer]
13. Is the color code sensor wrong?
1. Press the pop-up window, align the cutting line with the knife edge, press the reset button and then press start.
Fourteen, the knife reset sensor error?
1. Press the reset button to reset.
15. Is there inductive electricity when the hand touches the equipment?[cutting machine manufacturer]
1. Please ground the grounding wire.